Hello!!
New to this forum and not too sure if i'm in the correct place.
Thank you for having me!
I have a 2009 with 104k miles.. I changed the oil and a few days later,
P0017 and P000B showed themselves. I changed the CRANK position sensor and CPS on the exhaust side, inspected the wiring and connectors.. I clear the codes with a scan tool and the codes stay off for about three to four start up. After that, he Codes come back.. Sometimes including P0014 and sometimes not. I have a feeling changing the oil stirred something up and perhaps clogged the VVT Solenoid. I know there are (2) of these solenoids (intake side and Exhaust side)..
Can anyone tell me what is going on and or which solenoid I should clean or replace?
The jeep runs ok for the most part.. It sometimes runs rough at idle and I noticed the it idles a little up and down. Sometimes after hitting the gas, it drops to idle nicely and sometimes is hangs some..
It has stalled a few times and difficult to start..
Thank you for your help!!
New to this forum and not too sure if i'm in the correct place.
Thank you for having me!
I have a 2009 with 104k miles.. I changed the oil and a few days later,
P0017 and P000B showed themselves. I changed the CRANK position sensor and CPS on the exhaust side, inspected the wiring and connectors.. I clear the codes with a scan tool and the codes stay off for about three to four start up. After that, he Codes come back.. Sometimes including P0014 and sometimes not. I have a feeling changing the oil stirred something up and perhaps clogged the VVT Solenoid. I know there are (2) of these solenoids (intake side and Exhaust side)..
Can anyone tell me what is going on and or which solenoid I should clean or replace?
The jeep runs ok for the most part.. It sometimes runs rough at idle and I noticed the it idles a little up and down. Sometimes after hitting the gas, it drops to idle nicely and sometimes is hangs some..
It has stalled a few times and difficult to start..
Thank you for your help!!
