I like it! defenitely gonna get one hehe tnx for the upload

 

Looks good. Are the dimensions similar enough to make this project doable?

 

I really don't know, I need to find a junk yard with a totaled Renegade and take some measurements. Eyeballing it, it looks close

 

Looks very nice! Hope it'll fit.

 

To each his own...but I'm personally not a fan of that at all....just doesn't seem to fit.

 

Looks good...let us know how it goes
Rich

 

They look nice, but when would you use it? In CA, that would be road-illegal. And, if I'm off road at night, I won't be going so fast as the std lights would work. After all, the M38 doesn't have these extra lights and it does off road just fine--see War, Korean 1950-53, DMZ.

 

Just wondering, anybody did this already??? Does Libery's light bar fit our Patriots?

 

I am not 100% certain but I though a while back someone else had bought a light bar from a renegade....dont know of the outcome??? Maybe check forums.

 

I found this pic among profiles on the forum and tried to contact the member to get further info, without success. Anyone had better luck?

 

Good luck - I've been trying to find one in a boneyard for a while now to see how feasible it might be - I don't have the disposable income to just buy the kit from Mopar - I've been wondering if I could put one on my Compass Rallye for a while - I'll be interested to see what you find out.

 

Well, I would not mind buying a new one, if I was sure that it would fit, but to buy it and not to be able to fit it to my Pat it is something I am not willing to do.

 

Seems like its a pretty straight forward install.
http://www.lostkjs.com/forum/phpBB2/viewtopic.php?t=19754
http://www.jeepkj.com/forum/showthread.php?t=34988

Read through those links, while they are specific to KJs and not MKs, should still be applicable to install on the roof, based on the spacing and such of the holes I think it will fit on the Pat, I'm not sure about the angle/curve on the front. You will have to cut a hole for the electronics and run to the fuse but it should be no big deal. I'd fuse where the front bumper running lights are supposed to be done.

 

Installation itself is quite straight forward, but I am more worried about would the light bar curve fit the Patriot's roof curve. I measured the width and it is OK. Only curves of the bar and the roof are questionable.

 

I would just make a cardboard template of the roof curve of the Patriot (or Compass) and then trim the Libby's light to fit

 

Hope the original picture was photoshopped for more than lights

If your riot was sitting on lake ice you are braver than I am. Been there done that and watched a pick up truck sink majestically on some rotten ice.

 

If your riot was sitting on lake ice you are braver than I am. Been there done that and watched a pick up truck sink majestically on some rotten ice.

That's a Chrysler photoshoot spot. lol -- it's a soaking-wet parking lot, not ice.
They use that space a lot.. and for a long time; at least since '97 or so..

 

I hope someone figures this out b.c I am very eager to find out!!! Want on for myself!!!!!!!!!!!!!!

 

Anybody????

 

I don't think they're common enough to see if they'll fit. You could probably stop by a dealer to see if they have the part, and if they do, see if they'll "mock it up" for you; just to see if the part would fit the curve.