Jeep Patriot Forums banner

Oregon

3K views 5 replies 5 participants last post by  cloudspanda 
#1 ·
There is a huge lack of traffic in this area. Anyone from Portland here?
 
#4 ·
I had Hiway Fuel in Washougal do mine a few years ago. One thing they encountered while re-aligning was that the control arms (I think that's the right part) have to be removed everytime you need to re-adjust the camber. they said they had to put them on and take them off about a buhzillion times to get it right.

other than that, all turned out fine. I took a measurement with a tape to the ground from the fender before and after the job. Strangest thing is I only yeilded 1.5 inches of clearance. I'd suggest you try the same thing and see if you experience that.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top