Jeep Patriot Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
So, I did this the other day. Just thought I would share if anyone is looking where to drill.

I went behind the left fender because not much stuff can get in there, also my Jeep is undercoated so I didn’t want to drill in anything under too close. So, this was a great spot.

Make sure you seal it some how if you do this method. Cover all metal and all that good stuff. I used a power gun and just worked it through really slowly. No gaps no problems, she’s good.

Automotive tire Automotive design Motor vehicle Grey Automotive exterior

Automotive lighting Line Gas Kitchen utensil Eyewear

Automotive tire Hood Automotive lighting Vehicle Trunk

Tire Wheel Land vehicle Car Hand

Hood Automotive tire Automotive lighting Automotive design Tread

Tire Car Automotive tire Hood Motor vehicle
 
1 - 1 of 1 Posts
Top