Jeep Patriot Forums banner
Cancel

Search Results for ‘model’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results

Search Tags

158 2007 2008 2009 2010 2011 2012 2014 jeep patriot 2015 4wd 4x4 a/c abs aftermarket air conditioning alternator amp audio battery black bluetooth brakes bumper camper canada check engine light clutch compass custom cvt cvt issue diy electrical engine exhaust exterior fdii for sale headlight headlights hitch install intake manifold interior jeep jeep patriot latitude leak led lift lift kit light lights limited maintenance manual mods mpg navigation newbie noise off road oil oil change overheating paint patriot plasti dip rack radio rear repair rims roof rack rro rust seats snow speakers sport stereo stock subwoofer suspension throttle body tipm tire tires towing tpms transmission turbo uconnect warranty water water leak wheel wheels winter wiring
  1. Interior
    I am new to the forum, just got my 08 Patriot a few days ago after the loss of my previous ride. With that aside, I am very active with 3d modeling and printing. I would like to open this thread up to ask: 1) are there any other owners here with a 3d printer? 1a) if so, what have you...
    3d print model print
  2. Jeep Patriot General Discussion
    OK I wanted to simplify my signature and I also promised to share some details of my Pat, so here goes: ___ 2.4 Dual VVT-i gasoline Limited Export spec. 4x4 FreedomDrive I Original, standard accessories (I've marked some as "Limited only" meaning that the rest are standard in our Sport models...
    export model specs
  3. Exterior
    Hey everyone, just wondering if anybody uses Autodesk Inventor or Solidworks (or similar) and has already made any bit of a model of the front or rear panels and main frame members? I'm about to start taking measurements and building an accurate model so I can make a proper brushguard/pushbar...
    brushguard inventor model pushbar solidworks
1-3 of 3 Results
Top