|
kai 10-22-2007, 06:40 PM http://www.jcwhitney.com/autoparts/Product/tf-Browse/s-10101/Pr-p_Product.CATENTRY_ID:2005888/p-2005888/N-111+200732584+600003409/c-10101 possible way to crank out one or two inches of lift to a FDI-Pat? better than the rubber coil spacers? Gaze 10-22-2007, 07:57 PM its a quick way to destroy some pricey suspension components too! Mud 10-22-2007, 08:33 PM It doesn't say anywhere that they are spacers or give lift? Those things look like they clamp down on your springs to make it lower in the rear. I've never seen them before. You might as well take to your springs with a hacksaw. Terasec 10-23-2007, 08:48 AM It doesn't say anywhere that they are spacers or give lift? Those things look like they clamp down on your springs to make it lower in the rear. I've never seen them before. You might as well take to your springs with a hacksaw. I personally wouldnt use it for either, might good for show, but would not want to ride with them Boost sagging springs & restore vehicles to level Lower rear end for that low-slung look Raise front end to improve rear wheel traction | |